TSO Products 61-418A TDS-10 Dog Stop Complete Set

Infinitely Adjustable Material Stops For Your 20Mm Workbench
Infinite-and repeatable-position choices. You're no longer limited to one dog/clamping hole every 96mm.

The Festool MFT/3 multifunction table popularized the 20mm hole pattern, located 96mm on center. And for good reason: this hole pattern gives you flexibility in mounting dogs, clamps and other accessories, while keeping the table rigid and flat. But this design also has its drawbacks. Dogs could only be stopped 96mm apart with no choice in between. And horizontal clamps, cams or wedges work fine once-but cannot provide repeated accurate stops for cutting multiple identical workpieces.

TSO's variable position TDS-10 Dog Stops put an end to this limitation. With the TDS-10, you can now:

• Measure just once - Cut consistent, repeatable lengths on your MFT/3 or similar 20mm hole patterned worktable
• "Save" this position to use again later
• Accurately cut floating tenons with the Festool DOMINO joiner while these workpieces are securely positioned-no time-consuming and imprecise clamping
• Square cabinet door and drawer frames quickly
• At just 1/2" (12.7mm) thick, the TDS-10 also works well for holding down parts to be sanded

• (2) TS10 Dog Stops
• (2) DoubleGroove 20mm Bench Dogs
• (2) M8 SpeedKnobs

• Weight: 3.00 LBS