Seneca Woodworking SWD7IG04 Imperial Thickness Gauge for DF 700 (Requires Domi-Shim)
The Seneca Woodworking Imperial Thickness Gauge for the Festool Domino DF 700 allows you to quickly and effortlessly adjust the Domino fence offset to center your mortise on a variety of imperial material thicknesses. The gauge installs in less than a minute using a Torx T10 bit (not included), and is a direct replacement for the metric thickness gauge included with your Domino DF 700. The Imperial Thickness Gauge is CNC machined from Delrin material and designed to center on 1/2in., 5/8in., 3/4in., 7/8in., and 1in. nominal ply thicknesses.
The Seneca Woodworking Imperial Thickness Gauge for the Festool Domino DF 700 allows you to quickly and effortlessly adjust the Domino fence offset to center your mortise on a variety of imperial material thicknesses. The gauge installs in less than a minute using a Torx T10 bit (not included), and is a direct replacement for the metric thickness gauge included with your Domino DF 700. The Imperial Thickness Gauge is CNC machined from Delrin material and designed to center on 1/2in., 5/8in., 3/4in., 7/8in., and 1in. nominal ply thicknesses.
**NOTE!** This gauge requires one of our Domi-Shims to function properly. The Domino DF700 fence has a lower travel limit that would normally prevent it from centering on 1/2in.. 5/8in. or 3/4in. ply so a shim is required to enable centering on these thicknesses. The Imperial Thickness Gauge for DF700 is designed to work with the 1/2in. Seneca Woodworking Domi-Shim. We sell the Imperial Thickness Gauge two ways: In a set with the required shim, and by itself for people who already own the Seneca Woodworking Domi-Shim set. The D7IG04 Imperial Thickness Gauge will not work properly without this required shim installed.
- Weight: 1.00 LBS
Videos Hide Videos Show Videos
- Weight: 1.00 LBS
