The JDS 1996 Sensing Saf-Start helps to comply with OSHA's anti-automatic restart requirement. When installed on any equipment and there is an electrical power interruption to the equipment, the SENSING-SAF-START will open the circuit so when the power source is restored, it will prevent the equipment from restarting. Use this SENSING-SAF-START Plug on all 120 Volt powered machines that have good power cords on them already.
When a SENSING-SAF-START is installed on any equipment and there is an electrical power interruption to the equipment, the SENSING-SAF-START will open the circuit so when the power source is restored, the SENSING-SAF-START will prevent the equipment from restarting. The SENSING-SAF-START will not reset until the equipment switch has been turned in.offin.. There is a sensing circuit within the new SENSING-SAF-START that sends a signal up to the equipment switch to see if it is in the in.onin. position. If the switch is still in.onin., the SENSING-SAF-START sounds a warning buzz when the reset button is depressed, and it will not close the circuit until the equipment switch is turned in.offin.. Then, and only then, the SENSING-SAF-START will close the circuit, so the equipment will operate again.
- Short extension cord style.
- Fourteen inch cord on male plug end, twelve inch cord on female receptacle end.
- 120-volts, A.C., 15-amp, 50/60 cycle.
- Weight: 3.00 LBS
Videos Hide Videos Show Videos
- Weight: 3.00 LBS
